The keyboard is only really needed for setup. Anything much longer would be difficult to squeeze into the case. A SHORT GPIO 40 pin Male to Female ribbon cable.A Micro SD to SD Card Extension Cable Adapter Flexible Extender for Version 2 of the case.These can often be found as part of a starter kit. A mini HDMI to HDMI adaptor (for setup).A compatible power supply ( one with an integrated On/Off switch is a nice to have).Adafruit's estimate is $15 when they become available. If you search you will find them but way over priced. The instructions show the older model.) Note that these are in short supply and should be reasonably priced. Raspberry Pi Zero W OR Raspberry Pi Zero 2 W.If you are looking for the original STL files, they are available on Thingiverse. If you need the to install software for the original iUniker screen, jump to Step 16. These instructions and models have been updated to support the Waveshare display. Version 2 has the relocated SD card that is inserted in the front where the original Mac disk is.Ĭheck out the differences in Step 1. Version 1 has a Faux disk and the SD card is accessible from the right side. Note: The STLs are updated for use with an updated screen. All the other parts are readily available. You will need access to a 3d printer for the case. I was able to make a smaller, cheaper and simpler version.

Smaller, cheaper components and new fabrication methods have made the process far easier.

Times have changed and technology has moved on. I really wanted one but didn't have the time or resources. Years ago I saw that John Leake, of RetroMacCast, built a 1/3 scale Macintosh.

Check mac mini power supply